2.8mm coil RINA FH36 ocean engineering steel stockist

2.8mm coil RINA FH36 ocean engineering steel stockist

The weight of the ship plate can be set according to the weight required by the ship, so that neither the weight of the ship nor the speed of operation will be affected. The price of RINA FH36 ocean engineering steel, medium and thick ship plates is determined according to the thickness and quality, which can be combined with the cost of shipbuilding to calculate the price, and then make a choice, so that it will not affect the cost of shipbuilding.

We are a popular factory, supplier and wholesaler of mild steel plates and alloy steel plates in all over the globe. We follow all standards and specifications of RINA FH36 ocean engineering steel boiler steel plate, structural steel plate, shipbuilding steel plates and corten steel in different types. We manufacture and supply steel plates, steel section and steel structures according to customer’s demand. The company also focus on providing customers with RINA FH36 ocean engineering steel high-end steels and competitive price.

The advantages of RINA FH36 ocean engineering steel, medium and thick boiling steel plate: The surface is relatively smooth, the quality is good, and it is easy to process. Because medium and thick boiling steel plate does not have concentrated shrinkage holes, the amount of deoxidizer is small, and boiling steel plate price is lower than other steel plates. Disadvantages of medium and thick boiling steel plate: it has a lot of gas content and impurities, it is not easy to weld, and its bearing capacity is worse than other steel plates, so it is not suitable for parts that need to bear gravity.

RINA FH36 ocean engineering steel, Special thick steel plate cutting needs to be preheated in advance. Some steel plates are prone to cracks after entering the cutting process, sometimes that is because the temperature is too low, and it is necessary to perform pre-heat treatment in advance for such cases. The staff can preheat the steel plates first, so that the temperature of the steel plates will gradually increase, and then the flame gun can be used to cut. The probability of cracks in the cut material is very low, and the quality of the steel plate is also guaranteed.

Leave a Message